Control Panel Removal

Control Panel Removal

1 Screw 2 Control panel

To remove the control panel in the small form-factor chassis, perform the following steps:

1. Remove the drive shelf.
   
   
2. Remove the power supply.
   
   
3. Disconnect the control panel cable from the control panel connector on the system board (see "System Board Labels" for the location of the PANEL connector).
   
   Note the routing of the control panel cable as you remove it from the chassis.
   
   
4. From inside the chassis, remove the mounting screw that secures the control panel to the chassis.
   
   
5. Disconnect the chassis intrusion switch cable connector from the control panel.
   
   
6. Remove the control panel from the chassis.
   
   Note the routing of the control panel cable as you remove it from the chassis.

When you install the replacement control panel, be sure to put the right side of the control panel behind the mounting tab.